Meyertech ZoneVu 328 Series Guide de l'utilisateur télécharger pdf (Page 14)

MPOWER CCTV SYSTEM CONFIGURATION SOFTWARE ISSUE 05

MPOWER

Status

The status of the communications between the unit and Mpower. This will report :

No Response – no communication from unit

Response confirmed – communication received from unit

Save and Load

The “Save” and “Load” buttons are used to save and load the settings displayed on the current page.

For example, clicking “Save” on the dialog box shown above would save the displayed “Global Alarm” settings into the

relevant file in the current configuration directory structure – see the “Setup, Data

Location” section above. “Load” would

reverse the process, reading the settings from the file and showing them in the dialog box.

These same buttons can be used in combination with “<- ZoneVu” and “-> ZoneVu” to backup and restore the various

ZoneVu settings. For example, clicking “<- ZoneVu” copies the settings from the selected ZoneVu equipment and shows

them in the dialog. These setting can now be saved to disk by clicking the “Save” button. Clicking “Load” followed by “->

ZoneVu” would reverse the process, reading the settings from disk and then copying them to the ZoneVu equipment.

To summarize:

“Load” loads settings from the PC’s file system and shows them in Mpower,

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Pas de commentaire

Meyertech ZoneVu 328 Series Guide de l'utilisateur Page 14